🌱Megaponics← All guides
🍅
Hydroponic grow guide · Vegetables

Tomato

🌤️ Mild-temperature crop🪣 Dutch bucket (bato) · Drip / rockwool slab
TDS
600–1250 ppm
EC
1.2–2.5
pH
6–6.5
Stages
10
Day temp
68–79°F

Stage by stage

Seedling: in the tray or plug

Young roots burn easily, so the feed starts weak and steps up in 3 small steps (EC 0.3 → 0.5 → 0.7). Move on when the plant looks like the next step, not by the calendar.

1
Step 1 of 3 · Seed leaves open
Seed leaves open flat. The seed itself gets plain water only.
🧪 Feed — weigh into a fresh tank
Target TDS 150 ppm · EC 0.3 · pH 5.8

Mix in the calculator's order: Part A (Calcium Nitrate, Potassium Nitrate, Fe-EDTA), then Part B (MKP, Potassium Sulfate, Magnesium Sulfate), then the micro mix last. Dissolve each salt fully before the next, and never mix A and B together undiluted. Check TDS, then set pH to 5.8.

2
Step 2 of 3 · First true leaves
First jagged true leaves are showing.
🧪 Feed — weigh into a fresh tank
Target TDS 250 ppm · EC 0.5 · pH 5.8

Mix in the calculator's order: Part A (Calcium Nitrate, Potassium Nitrate, Fe-EDTA), then Part B (MKP, Potassium Sulfate, Magnesium Sulfate), then the micro mix last. Dissolve each salt fully before the next, and never mix A and B together undiluted. Check TDS, then set pH to 5.8.

3
Step 3 of 3 · Ready to transplant
Roots fill the plug — ready to move into the system.
🧪 Feed — weigh into a fresh tank
Target TDS 350–400 ppm · EC 0.7–0.8 · pH 5.8

Mix in the calculator's order: Part A (Calcium Nitrate, Potassium Nitrate, Fe-EDTA), then Part B (MKP, Potassium Sulfate, Magnesium Sulfate), then the micro mix last. Dissolve each salt fully before the next, and never mix A and B together undiluted. Check TDS, then set pH to 5.8.

After transplant: first days in your system

Moving a seedling tears its fine roots, so strength drops back down and climbs again over 3 steps (EC 0.3 → 0.5 → 0.7).

4
Step 1 of 3 · Just transplanted
Just moved. Strength drops back so roots settle.
🧪 Feed — weigh into a fresh tank
Target TDS 150 ppm · EC 0.3 · pH 5.8

Mix in the calculator's order: Part A (Calcium Nitrate, Potassium Nitrate, Fe-EDTA), then Part B (MKP, Potassium Sulfate, Magnesium Sulfate), then the micro mix last. Dissolve each salt fully before the next, and never mix A and B together undiluted. Check TDS, then set pH to 5.8.

5
Step 2 of 3 · Roots into system
New white roots are growing into the system.
🧪 Feed — weigh into a fresh tank
Target TDS 250 ppm · EC 0.5 · pH 5.8

Mix in the calculator's order: Part A (Calcium Nitrate, Potassium Nitrate, Fe-EDTA), then Part B (MKP, Potassium Sulfate, Magnesium Sulfate), then the micro mix last. Dissolve each salt fully before the next, and never mix A and B together undiluted. Check TDS, then set pH to 5.8.

6
Step 3 of 3 · Before crop feed
Settled in. Flush with plain water, then start Vegetative.
🧪 Feed — weigh into a fresh tank
Target TDS 350–400 ppm · EC 0.7–0.8 · pH 5.8

Mix in the calculator's order: Part A (Calcium Nitrate, Potassium Nitrate, Fe-EDTA), then Part B (MKP, Potassium Sulfate, Magnesium Sulfate), then the micro mix last. Dissolve each salt fully before the next, and never mix A and B together undiluted. Check TDS, then set pH to 5.8.

Growing: full feed

Roots are settled. The plant now gets its full recipe for each stage.

7
Vegetative
Until the plant is 14–16 in. tall.
🌡️ Target climate — this stage
Air · day
70–75°F21–24°C
Air · night
61–64°F16–18°C
Root zone
68–72°F20–22°C
Humidity
65–80%
VPD
0.8–1 kPa
PPFD
400–600 µmol
DLI
14–20 mol
Light hours
14–16 h
Duration
21–35 days

💡 Hold a moderate VPD: too low → soft vegetative growth, too high → hard/stunted (Resh §14.6).

🧪 Feed — weigh into a fresh tank
Target TDS 600–700 ppm · EC 1.2–1.4 · pH 6.0–6.5

Mix in the calculator's order: Part A (Calcium Nitrate, Potassium Nitrate, Fe-EDTA), then Part B (MKP, Potassium Sulfate, Magnesium Sulfate), then the micro mix last. Dissolve each salt fully before the next, and never mix A and B together undiluted. Check TDS, then set pH to 6.0–6.5.

8
Flowering
14–16 in. tall until the first truss's fruit is ¼–½ in. across.
🌡️ Target climate — this stage
Air · day
70–75°F21–24°C
Air · night
61–64°F16–18°C
Root zone
68–72°F20–22°C
Humidity
60–75%
VPD
0.8–1.1 kPa
PPFD
600–800 µmol
DLI
18–24 mol
Light hours
14–16 h
Duration
14–21 days

💡 Avoid a large day–night temperature gap: it makes clusters too upright and prone to kinking (Resh p402).

🧪 Feed — weigh into a fresh tank
Target TDS 850–950 ppm · EC 1.7–1.9 · pH 6.0–6.5

Mix in the calculator's order: Part A (Calcium Nitrate, Potassium Nitrate, Fe-EDTA), then Part B (MKP, Potassium Sulfate, Magnesium Sulfate), then the micro mix last. Dissolve each salt fully before the next, and never mix A and B together undiluted. Check TDS, then set pH to 6.0–6.5.

9
Fruiting
After the first fruit sets.
🌡️ Target climate — this stage
Air · day
70–75°F21–24°C
Air · night
64–65°F17.5–18.5°C
Root zone
68–72°F20–22°C
Humidity
60–75%
VPD
0.9–1.2 kPa
PPFD
700–900 µmol
DLI
20–30 mol
Light hours
14–16 h
Duration
35–60 days

💡 Calcium-critical stage: low Ca / erratic water → blossom-end rot (Resh deficiency key, p24).

🧪 Feed — weigh into a fresh tank
Target TDS 1100–1250 ppm · EC 2.2–2.5 · pH 6.0–6.5

Mix in the calculator's order: Part A (Calcium Nitrate, Potassium Nitrate, Fe-EDTA), then Part B (MKP, Potassium Sulfate, Magnesium Sulfate), then the micro mix last. Dissolve each salt fully before the next, and never mix A and B together undiluted. Check TDS, then set pH to 6.0–6.5.

10
Harvest
Picking — same recipe as Fruiting until the crop ends.
🌡️ Target climate — this stage
Air · day
70–75°F21–24°C
Air · night
64–65°F17.5–18.5°C
Root zone
68–72°F20–22°C
Humidity
60–75%
VPD
0.9–1.2 kPa
PPFD
700–900 µmol
DLI
20–30 mol
Light hours
14–16 h
Duration
30–90 days

💡 For indeterminate types, EC/temperature targets repeat per truss through the harvest window.

🧪 Feed — weigh into a fresh tank
Target TDS 1100–1250 ppm · EC 2.2–2.5 · pH 6.0–6.5

Mix in the calculator's order: Part A (Calcium Nitrate, Potassium Nitrate, Fe-EDTA), then Part B (MKP, Potassium Sulfate, Magnesium Sulfate), then the micro mix last. Dissolve each salt fully before the next, and never mix A and B together undiluted. Check TDS, then set pH to 6.0–6.5.

Fix a deficiency

Calcium
Blossom-end rot of fruit; growing tip necrotic, dieback, thick woody stems.
Fix: Calcium Nitrate
Iron
Interveinal yellowing of young leaves (veins stay green); small thin-stemmed flower clusters.
Fix: Fe-EDTA
Nitrogen
General chlorosis of older leaves; stems/petioles/lower leaf surfaces can turn purple.
Fix: Calcium Nitrate / Potassium Nitrate
Micronutrients (B/Mn/Zn/Cu/Mo)
Trace-element symptoms — e.g. boron shows as internal fruit browning, blotchy ripening, deformed growing tips.
Fix: Increase Micro Nutrient Mix